Home › Vehicle Exterior › WIPER / WASHER › RELAY (w/ Rear Wiper)
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261273 RELAY(w/ Rear Wiper) G

WIPER / WASHER  RELAY(w/ Rear Wiper)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 85941 2.REMOVE WASHER RR RELAY

E202166E01
1.071,4.022 1.315,4.227 0.244,0.205 10 *1 1.358,3.756 1.33,4.106 1.33,4.106 1.231,4.106 false

a.

Remove the washer RR relay from the engine room relay block.

Text in Illustration
*1 Washer RR Relay


Hide 85941 3.INSPECT WASHER RR RELAY

B242124E01
1.292,0.74 1.584,0.185 1.584,0.185 1.773,0.185 false 0.708,0.74 1,0.185 1,0.185 1.189,0.185 false 1.789,0.082 1.924,0.258 0.135,0.177 10 2 1.651,1.353 1.763,1.500 0.112,0.147 10 5 1.222,0.082 1.357,0.258 0.135,0.177 10 1 0.98,1.159 1.533,1.457 1.533,1.457 1.621,1.457 false 1.651,1.835 1.763,1.981 0.112,0.147 10 3 0.98,1.64 1.533,1.938 1.533,1.938 1.621,1.938 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the washer RR relay.



Hide 85941 4.INSTALL WASHER RR RELAY

a.

Install the washer RR relay to the engine room relay block.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL