Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261274 WASHER LEVEL WARNING SWITCH G

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 85397 1.INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:

The following check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.


a.

Fill the windshield washer jar assembly with washer fluid.


b.
E158668E02
2.663,1.168 2.798,1.344 0.135,0.177 10 S 0.578,1.171 0.713,1.348 0.135,0.177 10 E 2.019,1.269 2.608,1.269 false 1.388,1.26 0.752,1.26 false 0.206,0.14 0.470,0.317 0.265,0.177 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (S) - 2 (E) Fluid volume is more than 750 cc (45.7 cu.in.) 10 kΩ or higher
1 (S) - 2 (E) Fluid volume is less than 550 cc (33.5 cu.in.) Below 1 Ω


HINT:

When the fluid volume is between 550 and 750 cc (33.5 and 45.7 cu.in.), the level warning switch assembly may be on or off.


If the result is not as specified, replace the level warning switch assembly.

Text in Illustration
*a Component without harness connected
(Level Warning Switch Assembly)