Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2015.06–2017.08
RM27T0E _59 Vehicle Exterior _053747 LIGHTING (EXT) _0261275 LIGHTING SYSTEM D

LIGHTING (EXT)  LIGHTING SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


a.

Whenever a DTC is stored, the headlight swivel ECU stores the current vehicle (sensor) state as Freeze Frame Data.



CHECK FREEZE FRAME DATA


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / AFS / Trouble Codes.


e.

According to the display on the intelligent tester, select the trouble code data display with Freeze Frame Data.

AFS
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Headlight Low Beam State Low beam headlight state / ON or OFF ON: Low beam headlights on
OFF: Low beam headlights off
-
Headlight High Beam State High beam headlight state / ON or OFF ON: High beam headlights on
OFF: High beam headlights off
-
Engine Engine condition / Run or Stop Run: Engine running
Stop: Engine stopped
-
FR Wheel Speed Front right wheel speed / 0 to 327.67 km/h Condition can be displayed -
FL Wheel Speed Front left wheel speed / 0 to 327.67 km/h Condition can be displayed -
Vehicle Acceleration Vehicle acceleration / -455.65 to 445.6 m/s2 Condition can be displayed -
Leveling Motor Slave Status of the leveling motor slave / Normal or Abnormal Condition can be displayed -
Leveling Motor Over-Run Status of the leveling motor over-run / Normal or Abnormal Condition can be displayed -
+B IG power supply voltage value / 0 to 19.75 V 11 to 14 V -



CLEAR FREEZE FRAME DATA


NOTICE:

Clearing the DTCs will also clear the Freeze Frame Data.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Clear the DTCs and Freeze Frame Data (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).