The headlight leveling motor operates by receiving the signal from the headlight swivel ECU. The headlight swivel ECU detects the headlight leveling motor status using the signal from the headlight leveling motor.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2424 | ·
Malfunction in the headlight leveling motor LH. ·
Open or short in the headlight leveling motor LH communication circuit. |
·
Headlight leveling motor LH ·
Headlight swivel ECU assembly ·
Headlight unit LH ·
Harness or connector |
| B2425 | ·
Malfunction in the headlight leveling motor RH. ·
Open or short in the headlight leveling motor RH communication circuit. |
·
Headlight leveling motor RH ·
Headlight swivel ECU assembly ·
Headlight unit RH ·
Harness or connector |
Clear the DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
DTC B2424 or B2425 output does not occur.
OK
NG
Using the intelligent tester, read the Data List (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| +B | IG power supply voltage value / 0 to 19.75 V | 11 to 14 V | - |
Power supply voltage is 11 to 14 V.
OK
NG
Disconnect the A58 headlight swivel ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A58-22 (E1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Headlight Swivel ECU Assembly) |
OK
NG
Disconnect the A58 headlight swivel ECU assembly connector.
Disconnect the A30*1 or A31*2 headlight connector.
*1: for LH
*2: for RH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A58-30 (LH+) - A30-7 (LHM+) | Always | Below 1 Ω |
| A58-3 (LHT) - A30-6 (LHB1) | Always | Below 1 Ω |
| A58-27 (LH-) - A30-8 (LHE) | Always | Below 1 Ω |
| A58-30 (LH+) - Body ground | Always | 10 kΩ or higher |
| A58-3 (LHT) - Body ground | Always | 10 kΩ or higher |
| A58-27 (LH-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A58-11 (RH+) - A31-7 (RHM+) | Always | Below 1 Ω |
| A58-4 (RHT) - A31-6 (RHB1) | Always | Below 1 Ω |
| A58-28 (RH-) - A31-8 (RHE) | Always | Below 1 Ω |
| A58-11 (RH+) - Body ground | Always | 10 kΩ or higher |
| A58-4 (RHT) - Body ground | Always | 10 kΩ or higher |
| A58-28 (RH-) - Body ground | Always | 10 kΩ or higher |
OK
NG
for Halogen Headlight
Remove the headlight unit (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>DISASSEMBLY).
for LED Headlight
Remove the headlight unit (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>DISASSEMBLY).
Disconnect the headlight leveling motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (LHM+) - 2 (LHM+) | Always | Below 1 Ω |
| 6 (LHB1) - 1 (LHB1) | Always | Below 1 Ω |
| 8 (LHE) - 3 (LHE) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (RHM+) - 2 (RHM+) | Always | Below 1 Ω |
| 6 (RHB1) - 1 (RHB1) | Always | Below 1 Ω |
| 8 (RHE) - 3 (RHE) | Always | Below 1 Ω |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Halogen Headlight) | B |
| NG (LED Headlight) | C |
| *A | for LH |
| *B | for RH |
A
B
C
for Halogen Headlight
Temporarily replace the headlight leveling motor with a new or normally functioning one (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>DISASSEMBLY).
for LED Headlight
Temporarily replace the headlight leveling motor with a new or normally functioning one (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>DISASSEMBLY).
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
DTC B2424 or B2425 output does not occur.
| Result | Proceed to |
|---|---|
| OK (for Halogen Headlight) | A |
| OK (LED Headlight) | B |
| NG | C |
A
B
C