Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2015.06–2017.08
RM27T0E _59 Vehicle Exterior _053747 LIGHTING (EXT) _0261275 LIGHTING SYSTEM C

LIGHTING (EXT)  LIGHTING SYSTEM  U0101  Lost Communication with ECM  U0073  Control Module Communication Bus Off  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Skid Control ECU  U0142  Lost Communication with Main Body ECU  U1000  Can Communication Failure(Message Registry)  U1121  Lost Communication with Driver Seat Module  


DESCRIPTION

These DTCs are stored when the self-diagnosis of the headlight swivel ECU determines that the CAN communication system is malfunctioning.

DTC Code DTC Detection Condition Trouble Area
U0073 Control module communication bus is off. CAN communication system
U0100 Lost communication with the ECM/PCM "A".
U0101 Lost communication with the ECM.
U0126 Lost communication with the steering angle sensor.
U0129 Lost communication with the skid control ECU.
U0142 Lost communication with the main body ECU (multiplex network body ECU).
U1000 CAN communication failure.
U1121 Lost communication with the driver seat module.

PROCEDURE

1.CHECK FOR DTC
a.

for LHD with Entry and Start System

i.

Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING).



b.

for LHD without Entry and Start System

i.

Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING).



c.

for RHD with Entry and Start System

i.

Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING).



d.

for RHD without Entry and Start System

i.

Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING).



OK:

DTC output does not occur.


Result
Result Proceed to
OK A
NG (for for LHD with Entry and Start System) B
NG (for for LHD without Entry and Start System) C
NG (for for RHD with Entry and Start System) D
NG (for for RHD without Entry and Start System) E


A

B

C

D

E