84340
1.INSPECT STOP LIGHT SWITCH ASSEMBLY
Disconnect the stop light switch assembly connector.
Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (B) - 3 (GND) | Engine switch off | 11 to 14 V |
| 5 (B) - 3 (GND) | Engine switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (GND) - Body ground | Always | Below 1 Ω |
If the result is not as specified, repair or replace the wire harness or connector.
| *a | Front view of wire harness connector
(to Stop Light Switch Assembly) |
Reconnect the stop light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (L) - 3 (GND) | Engine switch off, brake pedal not depressed | Below 1 V |
| 2 (L) - 3 (GND) | Engine switch off, brake pedal depressed | 11 to 14 V |
| 4 (L) - 3 (GND) | Engine switch on (IG), brake pedal not depressed | 11 to 14 V |
| 4 (L) - 3 (GND) | Engine switch on (IG), brake pedal depressed | Below 1 V |
If the result is not as specified, replace the stop light switch assembly.
| *a | Component with harness connected
(Stop Light Switch Assembly) |