Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM27T0E _59 Vehicle Exterior _053747 LIGHTING (EXT) _0261294 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89407A 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

C214173E14
5.594,2.188 5.656,0.969 5.656,0.969 5.833,0.969 false 5.781,2.208 5.979,1.656 5.979,1.656 6.177,1.656 false 5.74,2.438 6.448,2.573 6.448,2.573 6.448,2.865 false 4.729,0.323 4.979,0.521 0.25,0.198 10 false *a 3.417,0.271 3.646,0.469 0.229,0.198 10 false *b 4.354,1.927 4.594,2.156 0.24,0.229 10 false *c 3.896,3.74 4.177,4.01 0.281,0.271 10 false *d 5.875,0.885 6.573,1.229 0.698,0.344 10 false SHRR 6.24,1.552 6.594,1.729 0.354,0.177 10 false SHB 6.292,2.885 6.656,3.083 0.365,0.198 10 false SHG

Text in Illustration
*a Component without harness connected
(Rear Height Control Sensor)
*b Min. Low
*c Normal *d Max. High
V100135

45°
V100136

45°

a.

Connect 3 dry batteries of 1.5 V in series.


b.

Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 3 (SHG).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 3 (SHG) Max. high (45°) 4.4 to 4.6 V
Normal (0°) 2.3 to 2.6 V
Min. low (-45°) 0.4 to 0.6 V


NOTICE:

Do not apply a voltage of 5 V or higher.


If the result is not as specified, replace the rear height control sensor sub-assembly.