51980
1.REMOVE PINTLE HOOK ASSEMBLY (w/ Pintle Hook)
For vehicles with a spare tire installed to the underbody, remove the spare tire.
Remove the 4 nuts.
Remove the 4 bolts and pintle hook.
58766A
2.REMOVE JACK BOX HOLE COVER
Using a screwdriver, detach the 2 claws and remove the jack box hole cover.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
52179B
3.REMOVE REAR BUMPER BAR PLATE
Put protective tape around the rear bumper bar plate.
Detach the 14 claws and remove the rear bumper bar plate.
| *1 | Protective Tape | - | - |
69411
4.REMOVE BACK DOOR CHECK
52162B
5.REMOVE NO. 1 REAR BUMPER PLATE
Put protective tape around the No. 1 rear bumper plate.
Remove the 2 bolts.
Detach the 21 claws and remove the No. 1 rear bumper plate.
| *1 | Protective Tape | - | - |
76626E
6.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
7.REMOVE REAR QUARTER PANEL MUDGUARD RH
Use the same procedure described for the LH side.
52159
8.REMOVE REAR BUMPER COVER (for 5 Door)
Put protective tape around the rear bumper cover.
Remove the 2 clips and 5 bolts.
Detach the 14 claws.
w/ TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 4 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
Disconnect the 2 connectors.
w/o TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 2 connectors.
Remove the rear bumper cover.
| *1 | Protective Tape | - | - |
52159
9.REMOVE REAR BUMPER COVER (for 3 Door)
Put protective tape around the rear bumper cover.
Remove the 2 clips and 5 bolts.
Detach the 10 claws.
w/ TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 4 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
Disconnect the 2 connectors.
w/o TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 2 connectors.
Remove the rear bumper cover.
| *1 | Protective Tape | - | - |
52169A
10.REMOVE NO. 3 REAR BUMPER SIDE SUPPORT
Remove the screw and No. 3 rear bumper side support.
52156A
11.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Using a clip remover, detach the 4 claws and remove the rear bumper side support.
Tape the clip remover tip before use.
| *1 | Protective Tape | - | - |
52155A
12.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52588
13.REMOVE REAR BUMPER END RETAINER LH (w/ Rear Bumper End Retainer)
Remove the screw and rear bumper end retainer.
52587
14.REMOVE REAR BUMPER END RETAINER RH (w/ Rear Bumper End Retainer)
Use the same procedure described for the LH side.
52174D
15.REMOVE REAR BUMPER BAR REINFORCEMENT LH
Remove the 3 bolts and rear bumper bar reinforcement.
52173D
16.REMOVE REAR BUMPER BAR REINFORCEMENT RH
Use the same procedure described for the LH side.
52158C
17.REMOVE NO. 2 REAR BUMPER SIDE SUPPORT LH
Remove the bolt and No. 2 rear bumper side support.
52186B
18.REMOVE REAR BUMPER SIDE MOUNTING BRACKET LH
w/ Entry and Start System:
Disconnect the connector.
Remove the bolt and rear bumper side moulding bracket.
52185B
19.REMOVE REAR BUMPER SIDE MOUNTING BRACKET RH
Use the same procedure described for the LH side.
89997
20.REMOVE ELECTRICAL KEY ANTENNA (w/ Entry and Start System)
Remove the bolt and electrical key antenna.