Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
63470B
1.REMOVE ROOF RACK ASSEMBLY LH (w/ Roof Rack)
Remove the roof rack (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>ROOF RACK>REMOVAL).
75597
2.REMOVE ROOF DRIP SIDE FINISH MOULDING JOINT COVER LH (w/o Roof Rack)
Use the same procedure to remove the roof drip side finish moulding joint cover on the other side.
Put protective tape around the roof drip side finish moulding joint cover.
Detach the 2 claws and remove the roof drip side finish moulding joint cover.
| *1 | Protective Tape |
75552
3.REMOVE ROOF DRIP SIDE FINISH MOULDING LH
Put protective tape around the roof drip side finish moulding.
Detach the clip and remove the roof drip side finish moulding.
When removing the rear roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clip.
If the roof drip side finish moulding clip is damaged or becomes detached from the vehicle, replace it with a new one.
| *1 | Protective Tape |
75558C
4.REMOVE CENTER NO. 2 ROOF DRIP SIDE FINISH MOULDING LH
Put protective tape around the center No. 2 roof drip side finish moulding.
Remove the center No. 2 roof drip side finish moulding.
| *1 | Protective Tape |
75556C
5.REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH
Put protective tape around the center roof drip side finish moulding.
Remove the center roof drip side finish moulding.
| *1 | Protective Tape |
75554A
6.REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH
Put protective tape around the rear roof drip side finish moulding.
Detach the clip and remove the rear roof drip side finish moulding.
When removing the rear roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clip.
If the roof drip side finish moulding clip is damaged or becomes detached from the vehicle, replace it with a new one.
| *1 | Protective Tape |