When installing the back door outside garnish protector, heat the rear lower license plate bracket and back door ornament surface using a heat light.
| Item | Temperature |
|---|---|
| Rear Lower License Plate Bracket | 20 to 30°C (68 to 86°F) |
| Back Door Ornament | 20 to 30°C (68 to 86°F) |
Do not heat the back door outside garnish excessively.
76825
1.INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR
for Rear Lower License Plate Bracket:
When using a new rear lower license plate bracket:
Clean the rear lower license plate bracket surface.
Using a heat light, heat the rear lower license plate bracket surface.
When reusing the rear lower license plate bracket:
Using a heat light, heat the rear lower license plate bracket surface.
Remove the double-sided tape from the rear lower license plate bracket.
Wipe off any tape adhesive residue with cleaner.
Install the back door outside garnish protector.
for Rear License Light Cover:
When using a new back door ornament:
Clean the rear back door ornament surface.
Using a heat light, heat the back door ornament surface.
When reusing the back door ornament:
Using a heat light, heat the back door ornament surface.
Remove the double-sided tape from the back door ornament.
Wipe off any tape adhesive residue with cleaner.
Install the back door outside garnish protector.
75435C
2.INSTALL BACK DOOR ORNAMENT
Attach the 6 claws to install the back door ornament.
84945
3.INSTALL LUGGAGE ELECTRICAL KEY SWITCH (w/ Entry and Start System)
81270
4.INSTALL LICENSE PLATE LIGHT ASSEMBLY
Install the license plate light with the 4 screws.
75132
5.INSTALL REAR LICENSE LIGHT COVER
Install the rear license light cover with the 5 screws.
81275A
6.INSTALL LICENSE PLATE LIGHT CORD (w/o Entry and Start System)
Connect the connector to install the license plate cord.