Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260991 NAVIGATION SYSTEM(for Navigation Receiver Type) Y

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the navigation system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
·

When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points in problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms


Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard Voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.



Result:
Proceed to
NEXT



NEXT

4.CHECK CABIN
4.CHECK CABIN
a.

Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

OK:

Condensation is not likely being produced and the temperature is not high or extremely low.


HINT:
·

A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

·

The navigation system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.




Result:
Proceed to
OK
NG



OK

5.CHECK VEHICLE CONDITION

NG

SET CABIN TO APPROPRIATE TEMPERATURE

5.CHECK VEHICLE CONDITION
a.

Check the vehicle condition.


Result:
Result Proceed to
except Pioneer Made A
for Pioneer Made B



A

6.CHECK NAVIGATION SYSTEM NORMAL CONDITION

B

17.CHECK SD CARD
6.CHECK NAVIGATION SYSTEM NORMAL CONDITION

Result:
Result Proceed to
Symptom is not normal operation. A
Symptom is normal operation. B



A

7.CHECK CAN COMMUNICATION SYSTEM*

B

SYMPTOM IS NORMAL OPERATION

7.CHECK CAN COMMUNICATION SYSTEM*

Result:
Result Proceed to
CAN DTCs are not output. A
CAN DTCs are output. (for LHD) B
CAN DTCs are output. (for RHD) C



A

8.CHECK FOR DTC*

B

C

8.CHECK FOR DTC*

Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B



A

9.DTC CLEAR*

B

11.CHECK SD CARD
9.DTC CLEAR*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DTC CHECK / CLEAR

HINT:

The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.



Result:
Proceed to
NEXT



NEXT

10.RECHECK FOR DTC*
10.RECHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DTC CHECK / CLEAR

Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B


HINT:
·

Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.

·

Check the DTCs and inspect the area that the code indicates.





B

11.CHECK SD CARD

A

28.DIAGNOSTIC TROUBLE CODE CHART
11.CHECK SD CARD
a.

Enter the "SD Check" screen. Refer to Check SD Card in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>OPERATION CHECK


Result:
Result Proceed to
"OK" is displayed. A
"NG" is displayed. B



A

12.PROBLEM SYMPTOMS TABLE

B

REPLACE SD CARD

12.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B


HINT:

If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>PROBLEM SYMPTOMS TABLE




A

13.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

13.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

NEXT

14.CHECK CIRCUIT
14.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

15.RECHECK FOR DTC
15.RECHECK FOR DTC

NEXT

16.PERFORM CONFIRMATION TEST
16.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END

17.CHECK SD CARD
a.

Check that the navigation screen is displayed when the "HOME" switch is pressed.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>OPERATION CHECK


Result:
Result Proceed to
The navigation screen is displayed. A
The navigation screen is not displayed, a warning message is displayed, and the navigation system continues to operate in audio mode. B
The navigation system does not respond when the "HOME" switch is pressed. C



A

18.CHECK NAVIGATION SYSTEM NORMAL CONDITION

B

REPLACE SD CARD

C

23.PROBLEM SYMPTOMS TABLE
18.CHECK NAVIGATION SYSTEM NORMAL CONDITION

Result:
Result Proceed to
Symptom is not normal operation. A
Symptom is normal operation. B



A

19.CHECK CAN COMMUNICATION SYSTEM*

B

SYMPTOM IS NORMAL OPERATION

19.CHECK CAN COMMUNICATION SYSTEM*
a.

Check if CAN communication system DTCs are output.

for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING

for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING

Result:
Result Proceed to
CAN DTCs are not output. A
CAN DTCs are output. (for LHD) B
CAN DTCs are output. (for RHD) C




A

20.CHECK FOR DTC*

B

C

20.CHECK FOR DTC*

Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B



A

21.DTC CLEAR*

B

23.PROBLEM SYMPTOMS TABLE
21.DTC CLEAR*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DTC CHECK / CLEAR

HINT:

The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.



Result:
Proceed to
NEXT



NEXT

22.RECHECK FOR DTC*
22.RECHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DTC CHECK / CLEAR

Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B


HINT:
·

Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.

·

Check the DTCs and inspect the area that the code indicates.





B

23.PROBLEM SYMPTOMS TABLE

A

29.DIAGNOSTIC TROUBLE CODE CHART
23.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B


HINT:

If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>PROBLEM SYMPTOMS TABLE




A

24.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

24.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

NEXT

25.CHECK CIRCUIT
25.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

26.RECHECK FOR DTC
26.RECHECK FOR DTC

NEXT

27.PERFORM CONFIRMATION TEST
27.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END

28.DIAGNOSTIC TROUBLE CODE CHART

*1: w/ Rear Seat Entertainment System

*2: w/ Parking Assist Monitor System (w/ Side Monitor System)

*3: w/ Wide View Front Monitor System

*4: w/ Side Monitor System

*5: w/ Rear View Monitor System (for Navigation Receiver Type)

*6: w/ Parking Assist Monitor System (for Camera built-in ECU)


a.

Find the output code in Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
·

The navigation system outputs DTCs for thefollowing system.

·

When DTCs other than those in Diagnostic Trouble Code Chart for the navigation system are output, refer to Diagnostic Trouble Code Chart for the relevant system.




Result:
Result Proceed to
DTCs for the rear seat entertainment system are output.*1 A
DTCs for the parking assist monitor system (w/ Side Monitor System) are output.*2 B
DTCs for the wide view front monitor system are output.*3 C
DTCs for the side monitor system are output.*4 D
DTCs for the rear view monitor system (for Radio and Display Receiver Type) are output.*5 E
DTCs for the parking assist monitor system (for Camera built-in ECU) are output.*6 F
DTCs for the navigation system are output. G



A

B

C

D

E

F

G

14.CHECK CIRCUIT
29.DIAGNOSTIC TROUBLE CODE CHART

*1: w/ Rear Seat Entertainment System

*2: w/ Parking Assist Monitor System (w/ Side Monitor System)

*3: w/ Wide View Front Monitor System

*4: w/ Side Monitor System

*5: w/ Rear View Monitor System (for Navigation Receiver Type)

*6: w/ Parking Assist Monitor System (for Camera built-in ECU)


a.

Find the output code in Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Navigation Receiver Type)>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
·

The navigation system outputs DTCs for thefollowing system.

·

When DTCs other than those in Diagnostic Trouble Code Chart for the navigation system are output, refer to Diagnostic Trouble Code Chart for the relevant system.




Result:
Result Proceed to
DTCs for the rear seat entertainment system are output.*1 A
DTCs for the parking assist monitor system (w/ Side Monitor System) are output.*2 B
DTCs for the wide view front monitor system are output.*3 C
DTCs for the side monitor system are output.*4 D
DTCs for the rear view monitor system (for Radio and Display Receiver Type) are output.*5 E
DTCs for the navigation system are output. F



A

B

C

D

E

F

25.CHECK CIRCUIT