Use these procedures to troubleshoot the LIN communication system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the intelligent tester, inspect the CAN communication function to make sure that there are no malfunctions in the communication system
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs are output (for LHD with Entry and Start system) | B |
| DTCs are output (for LHD without Entry and Start system) | C |
| DTCs are output (for RHD with Entry and Start system) | D |
| DTCs are output (for RHD without Entry and Start system) | E |
A
B
C
D
E
Using the intelligent tester, inspect the LIN communication function to make sure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Refer to the Problem Symptoms Table.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in problem symptoms table |
| Fault is listed in problem symptoms table |
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Data List / Active Test
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT