Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260912 VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) Y

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Interview the customer and confirm the trouble.

HINT:

Interview the customer to confirm the following:

·

History of brake fluid replacement.

·

Whether the engine was stopped intentionally when driving.

·

Whether the brake and accelerator pedals were depressed simultaneously.




Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

4.CHECK DTC AND FREEZE FRAME DATA*
4.CHECK DTC AND FREEZE FRAME DATA*
a.

Check and record output DTCs and the freeze frame data.



c.

Reconfirm the DTCs.

1.

Reconfirm the DTCs based on the recorded output DTCs and freeze frame data (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR for DTC Check/Clear, or See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>FREEZE FRAME DATA for Freeze Frame Data).

HINT:

If DTC U0073, U0100, U0114, U0123, U0124 or U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>CHECK FOR INTERMITTENT PROBLEMS).


Result:
Result Proceed to
DTC output A
DTC not output (Problem symptom does not occur) B
DTC not output (Problem symptom occurs) C





A

5.DIAGNOSTIC TROUBLE CODE CHART

B

6.SYMPTOM SIMULATION

C

7.PROBLEM SYMPTOMS TABLE
5.DIAGNOSTIC TROUBLE CODE CHART

NEXT

8.CIRCUIT INSPECTION*
6.SYMPTOM SIMULATION

NEXT

7.PROBLEM SYMPTOMS TABLE
7.PROBLEM SYMPTOMS TABLE

NEXT

8.CIRCUIT INSPECTION*
8.CIRCUIT INSPECTION*
Result:
Proceed to
NEXT



NEXT

9.IDENTIFICATION OF PROBLEM
9.IDENTIFICATION OF PROBLEM
Result:
Proceed to
NEXT



NEXT

10.REPAIR OR REPLACE
10.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST*
11.CONFIRMATION TEST*
Result:
Proceed to
NEXT



NEXT

END