Use the following procedures to troubleshoot the front power seat control system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC or airbag system DTC by simulating the symptoms indicated by the DTC.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD with Entry and Start System) | B |
| CAN DTC is output (for LHD without Entry and Start System) | C |
| CAN DTC is output (for RHD with Entry and Start System) | D |
| CAN DTC is output (for RHD without Entry and Start System) | E |
| Airbag system DTC is output | F |
A
B
C
D
E
F
Refer to Problem Symptoms Table.
(See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>PROBLEM SYMPTOMS TABLE).
| Proceed to |
|---|
| NEXT |
NEXT
Operation Check
(See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>OPERATION CHECK)
Data List / Active Test
(See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>DATA LIST / ACTIVE TEST)
Terminals of ECU
(See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>TERMINALS OF ECU)
Inspection
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT