The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use these procedures to troubleshoot the wireless door lock control system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Recheck for DTCs (Click here Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System)>DTC CHECK / CLEAR). Based on the DTCs output above, try to force output of the same CAN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| CAN communication system DTC is output (for LHD with Entry and Start System) | B |
| CAN communication system DTC is output (for RHD with Entry and Start System) | C |
| Wireless door lock control system DTC is output | D |
A
B
C
D
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Operation Check.
Terminals of ECU.
Data List / Active Test.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT