Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
87130D
1.REMOVE BLOWER ASSEMBLY
Remove the screw.
Disconnect the connector and clamp.
Detach the 2 claws and remove the blower unit assembly.
55950G
2.REMOVE DEFROSTER NOZZLE ASSEMBLY
Detach the 6 claws and remove the defroster nozzle assembly.
88669B
3.REMOVE ASPIRATOR HOSE
Detach the 2 claws and remove the aspirator hose.
88539J
4.REMOVE DRAIN COOLER HOSE
Remove the drain cooler hose.
87710G
5.REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)
87107A
6.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Remove the 2 screws and 2 radiator brackets.
Remove the heater radiator unit sub-assembly.
7.REMOVE AIR CONDITIONING HARNESS
Disconnect the connectors.
Detach the clamps and remove the harness.
88710H
8.REMOVE AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the packing.
Remove the butyl tape.
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts, air conditioning tube and accessory assembly.
88515
9.REMOVE COOLER EXPANSION VALVE
Remove the 2 O-rings from the air conditioning tube and accessory assembly.
Remove the expansion valve.
87106D
10.REMOVE DAMPER SERVO SUB-ASSEMBLY LH
Remove the 4 screws and damper servo sub-assembly LH.
87106L
11.REMOVE DAMPER SERVO SUB-ASSEMBLY RH
Remove the 3 screws and damper servo sub-assembly RH.
88501
12.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove the 6 screws.
Detach the 4 claws and remove the unit case.
Remove the evaporator.
Remove the 2 O-rings from the evaporator.
88625
13.REMOVE NO. 1 COOLER THERMISTOR
Remove the No. 1 cooler thermistor.