88625
1.INSTALL NO. 1 COOLER THERMISTOR
If reusing the evaporator, do not insert the sensor into a location where the sensor was previously inserted.
Insert the sensor to a location that is 1 fin to the right or left of its previous location.
| Area | Specified Condition |
|---|---|
| a | 50 mm (1.97 in.) |
| b | 46.7 mm (1.84 in.) |
| c | 33.3 mm (1.31 in.) |
| d | 154.1 mm (6.07 in.) |
| e | 25 mm (0.98 in.) |
| *1 | 1 Fin |
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.
| Refrigerant | Compressor Oil |
|---|---|
| HFC-134a (R134a) | ND-OIL 8 or equivalent |
| HFO-1234yf (R1234yf) | ND-OIL 12 or equivalent |
Install the 2 O-rings to the evaporator.
Install the evaporator.
Attach the 4 claws to install the unit case.
Install the 6 screws.
87106D
3.INSTALL DAMPER SERVO SUB-ASSEMBLY LH
Align the grooves on the damper servo sub-assembly with the protrusions on the unit and install the damper servo sub-assembly.
| *A | for Automatic Air conditioning System | - | - |
| *a | Air Conditioning Unit Side | *b | Damper Servo Side |
Install the 4 screws.
87106L
4.INSTALL DAMPER SERVO SUB-ASSEMBLY RH
Align the grooves on the damper servo sub-assembly with the protrusions on the unit and install the damper servo sub-assembly.
| *a | Air Conditioning Unit Side | *b | Damper Servo Side |
Install the 3 screws.
88515
5.INSTALL COOLER EXPANSION VALVE
Install the expansion valve.
88710H
6.INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.
| Refrigerant | Compressor Oil |
|---|---|
| HFC-134a (R134a) | ND-OIL 8 or equivalent |
| HFO-1234yf (R1234yf) | ND-OIL 12 or equivalent |
Install the 2 O-rings to the air conditioner tube and accessory assembly.
Using a 4 mm hexagon wrench, install the 2 bolts.
Install new butyl tape.
Install new packing.
7.INSTALL AIR CONDITIONING HARNESS
Attach the clamps to install the harness.
Connect the connectors.
87107A
8.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
Install the radiator.
Install the 2 brackets with the 2 screws.
87710G
9.INSTALL QUICK HEATER ASSEMBLY (w/ PTC Heater)
88539J
10.INSTALL DRAIN COOLER HOSE
install the drain cooler hose.
88669B
11.INSTALL ASPIRATOR HOSE
Attach the 2 claws to install the aspirator hose.
55950G
12.INSTALL DEFROSTER NOZZLE ASSEMBLY
Attach the 6 claws to install the defroster nozzle assembly.
87130D
13.INSTALL BLOWER ASSEMBLY
Attach the 2 claws to install the blower unit assembly.
Install the screw.