The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio and display receiver assembly, telematics transceiver* or speakers.
*: w/ Telematics Transceiver
Disconnect the H68 No. 1 stereo jack adapter assembly connector.
Disconnect the H51 radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H68-8 (VAL+) - H51-28 (VAL+) | Always | Below 1 Ω |
| H68-7 (VAR+) - H51-26 (VAR+) | Always | Below 1 Ω |
| H68-9 (VA-) - H51-27 (VA-) | Always | Below 1 Ω |
| H68-12 (AGND) - H51-11 (AGND) | Always | Below 1 Ω |
| H68-10 (ADPG) - H51-25 (ADPG) | Always | Below 1 Ω |
| H51-12 (SG) - Body ground | Always | 10 kΩ or higher |
| H68-8 (VAL+) - Body ground | Always | 10 kΩ or higher |
| H68-7 (VAR+) - Body ground | Always | 10 kΩ or higher |
| H68-9 (VA-) - Body ground | Always | 10 kΩ or higher |
| H68-12 (AGND) - Body ground | Always | 10 kΩ or higher |
| H68-10 (ADPG) - Body ground | Always | 10 kΩ or higher |
OK
NG