Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM › 2016.08–2021.06
RM27T0E _56 Audio / Visual / Telematics _056796 TELEMATICS _0277431 TELEMATICS SYSTEM U

TELEMATICS  TELEMATICS SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Telematics / Data List.


e.

According to the display on the GTS, read the "Data List".

Telematics System
Tester Display Measurement Item Range Normal Condition Diagnostic Note
VIN VIN registered to the telematics transceiver 17 digits Vehicle VIN displayed -
Unsent Emergency Call Number Number of times an emergency call has failed Min.: 0, Max.: 255 0 -
Activation Status Telematics transceiver activation status Shipping(Disable), Shipping(Enable), Full Services, Full Services & F&I Service, eCall only eCall only -
Backup Battery Status Mobilephone battery replacement flag Normal or Replace Normal -
Number of Trouble Codes The number of the DTC which is currently output Min.: 0, Max.: 255 Number of stored DTCs displayed -



ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Telematics / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Active Test Screen Description
Tester Display Measurement Item Control Range Diagnostic Note
Beep
·

Operate front No. 1 speaker assembly RH and front No. 2 speaker assembly RH*1

·

Operate front No. 2 speaker assembly RH and front No. 3 speaker assembly RH*2


OFF, ON -

*1: for 6 Speakers

*2: except 6 Speakers