This DTC is stored when the Vehicle Identification Number (VIN) is not stored in the telematics transceiver or when the VIN stored in the telematics transceiver and the VIN stored in the ECM do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F0 | VIN Not Programmed or Mismatch - DCM | When either of the following conditions is met:
·
The VIN is not stored in the telematics transceiver. ·
The VIN stored in the telematics transceiver and the VIN stored in the ECM do not match. |
·
SFI system ·
ECD system ·
CAN communication system |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 10 seconds.
Turn the GTS on.
Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization
According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check if CAN communication system DTCs are output.
for LHD with Entry and Start System: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD without Entry and Start System: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
CAN communication system DTCs are not output.
| Result | Proceed to |
|---|---|
| OK (SFI SYSTEM) | A |
| OK (ECD SYSTEM) | B |
| NG | C |
A
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
for 2TR-FE: Click hereEngine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
for LHD with Entry and Start System: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD without Entry and Start System: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING