Home › Engine / Hybrid System › 1GD-FTV (LUBRICATION) › OIL LEVEL SENSOR › 2016.08–2017.08
RM27T0E _51 Engine / Hybrid System _053690 1GD-FTV LUBRICATION _0260708 OIL LEVEL SENSOR G

1GD-FTV LUBRICATION  OIL LEVEL SENSOR  INSPECTION  


PROCEDURE

Hide 89491 1.INSPECT ENGINE OIL LEVEL SENSOR

a.
A362970C02
0.083,0.073 0.302,0.25 0.219,0.177 10 false *a 0.948,2.563 1.198,2.75 0.25,0.188 10 true *b 0.927,2.021 1.208,2.208 0.281,0.188 10 false *c
*a Component without harness connected
(Engine Oil Level Sensor)
*b On
*c Off


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 On at below 40°C Below 1 Ω
Off at below 40°C Below 1 Ω
On at 60°C or higher Below 1 Ω
Off at 60°C or higher 10 kΩ or higher


CAUTION:
·

Do not put your hands in the water warmed up during the inspection.

·

Touching the hot water may result in burns.



NOTICE:

When checking the engine oil level sensor in water, do not allow water to contact the terminals. After completing the check, dry the engine oil level sensor.


HINT:
·

In addition to a level switch, the oil level sensor also has a temperature switch. Therefore, make sure to check the oil level sensor at both high and low temperatures.

·

If the result is not as specified, replace the engine oil level sensor.