Home › Drivetrain › VF4BM (TRANSFER / 4WD / AWD) › 4WD CONTROL SWITCH(w/ Combination Switch) › from 2017.08
RM27T0E _52 Drivetrain _053703 VF4BM TRANSFER / 4WD / AWD _0260847 4WD CONTROL SWITCH(w/ Combination Switch) G

VF4BM TRANSFER / 4WD / AWD  4WD CONTROL SWITCH(w/ Combination Switch)  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT COMBINATION SWITCH ASSEMBLY (4WD CONTROL SWITCH)

a.
C354057C02
1.229,1.906 1.479,1.906 1.479,1.906 1.479,1.406 true 2.135,1.906 1.969,1.906 1.969,1.906 1.969,1.406 true 0.906,1.823 1.365,2.021 0.458,0.198 10 false GND 2.208,1.823 2.667,2.104 0.458,0.281 10 false LO 0.083,0.083 0.333,0.333 0.25,0.25 10 false *a
*a Component without harness connected
(Combination Switch Assembly (4wd Control Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (LO) - 4 (GND) H4 10 kΩ or higher
L4 Below 1 Ω


If the result is not as specified, replace the combination switch assembly (4wd control switch).


b.
C381463C01
0.698,0.844 0.698,0.344 0.698,0.344 0.865,0.344 true 2.875,1.313 2.875,1.813 2.875,1.813 2.708,1.813 true 1.604,1.094 1.604,0.427 1.604,0.427 1.771,0.427 true 2.427,1.719 2.854,1.938 0.427,0.219 10 false ILL+ 1.833,0.323 2.26,0.542 0.427,0.219 10 false ILL- 1.344,0.063 1.656,0.219 0.313,0.156 10 false *a 0.906,0.26 1.219,0.417 0.313,0.156 10 false *b
*a Component without harness connected
(Combination Switch Assembly (4wd Control Switch))
*b Combination Switch Assembly (4wd Control Switch) Illumination


Apply battery voltage between the terminals of the switch, and check the illumination condition of the center cluster module switch (4wd control switch).

Standard:
Measurement Condition Switch Condition
Battery positive (+) → 13 (ILL+) Battery negative (-) → 12 (ILL-) Illuminates


If the result is not as specified, replace the combination switch assembly (4wd control switch).