When disassembling the fog light assembly, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
STATIC ELECTRICITY COUNTERMEASURES SST
SST:Desktop anti-static mat set (09890-47010)
Wristband
09891-04020
Wristband connection wire (No. 1 grounding wire)
09891-04030
Anti-static mat
09891-04010
Ground connection wire (No. 2 grounding wire)
09891-04040
PRECAUTIONS DURING REPLACEMENT
Precautions during procedures:
Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.
To prevent damage to electrical equipment, disconnect the battery power supply before installing and removing electrical equipment.
Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.
When performing procedures, do not allow clothing to come near or contact parts.
Wear the SST (wristband) firmly on your wrist.
09891-04020
Connect the SST (No. 2 grounding wire) and SST (anti-static mat) to an appropriate grounding point in the workspace and on the work table.
09891-04040
09891-04010
When working inside the vehicle:
Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.
Connect SST (No. 1 grounding wire), SST (wristband) and SST (anti-static mat).
09891-04030
Always place the fog light assembly and its components on SST (anti-static mat).