Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45287
2.REMOVE LOWER STEERING COLUMN COVER
Turn the steering wheel to the left as necessary to remove the screw.
Turn the steering wheel to the right as necessary to remove the screw.
for Power Tilt and Power Telescopic:
Remove the screw.
Detach the 2 claws and remove the lower steering column cover.
45286B
3.REMOVE UPPER STEERING COLUMN COVER
Detach the 4 clips and claw to remove the upper steering column cover.
84650
4.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Disconnect the 2 connectors.
Detach the claw and remove the windshield wiper switch assembly.