Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
With the engine running, check the position that the washer fluid hits the windshield.
Washer fluid hits the windshield in the areas shown in the illustration.
| *1 | Ceramic Line | - | - |
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
|
Washer Fluid Spray Area | - | - |
| Area | Specified Condition | Area | Specified Condition |
|---|---|---|---|
| A | 72 mm (2.835 in.) | B | 305 mm (12.008 in.) |
| C | 127 mm (5.000 in.) | D | 11 mm (0.433 in.) |
If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.