Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
53341B
1.REMOVE HOOD INSULATOR (w/ Heater Nozzle)
85035
2.REMOVE WASHER NOZZLE SUB-ASSEMBLY
w/o Heater Nozzle:
|
Protective Tape |
Using a screwdriver, detach the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.
Be careful not to damage the windshield.
Tape the screwdriver tip before use.
Remove the washer nozzle sub-assembly from the washer hose.
Washer nozzles cannot be reused.
w/ Heater Nozzle:
|
Protective Tape |
Using a screwdriver, detach the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.
Be careful not to damage the windshield and washer nozzle sub-assembly.
Tape the screwdriver tip before use.
Disconnect the connector and washer hose and remove the washer nozzle sub-assembly.
Washer nozzles cannot be reused.