Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH › from 2017.08
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261272 HEADLIGHT CLEANER SWITCH G

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  INSPECTION  


PROCEDURE

Hide 84150D 1.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY

B487063C01
0.604,1.802 1.073,1.333 true 2.771,1.813 2.344,1.333 true 0.115,0.115 0.427,0.271 0.313,0.156 10 false *a 0.438,1.854 1.052,2.052 0.615,0.198 10 false ILL+ 2.688,1.854 3.302,2.052 0.615,0.198 10 false ILL-
*a Component without harness connected
(Headlight Cleaner Switch Assembly)


a.

Inspect the headlight cleaner switch assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 - 5 Headlight cleaner switch on Below 1 Ω
Headlight cleaner switch off 10 kΩ or higher


If the result is not as specified, replace the headlight cleaner switch assembly.



b.

Inspect the Illumination.

i.

Apply battery voltage to the connector and check the illumination condition.

OK:
Battery Connection Specified Condition
Battery positive (+) → 6 (ILL+)
Battery negative (-) → 1 (ILL-)
Illuminates


If the result is not as specified, replace the headlight cleaner switch assembly.