Home › Drivetrain › VF4BM (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM › from 2017.08
RM27T0E _52 Drivetrain _053703 VF4BM TRANSFER / 4WD / AWD _0260838 TRANSFER SYSTEM C

VF4BM TRANSFER / 4WD / AWD  TRANSFER SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication With Vehicle Dynamics Control Module  


DESCRIPTION

This DTC is output when communication is lost with the skid control ECU (master cylinder solenoid)*1, skid control ECU (brake actuator assembly)*2 or ECM.

*1: for Hydraulic Brake Booster

*2: for Vacuum Brake Booster


DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
U0100
1.

Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)

2.

Communication is lost between ECM and 4 wheel drive control ECU

3.

5.12 seconds or more when transfer is switching between high and low

4.

1 trip detection logic


CAN communication system
U0122
1.

Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)

2.

Communication is lost between skid control ECU and 4 wheel drive control ECU

3.

0.72 seconds or more when transfer is switching between high and low, when center differential is switching between free and lock, or when rear differential is switching between free and lock*

4.

1 trip detection logic


CAN communication system

*: w/ Rear Differential Lock


CAUTION / NOTICE / HINT

NOTICE:
·

When the data in the ECM, skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 is being overwritten, the indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

·

Clear all DTCs, since DTCs are stored after the data in the ECM, skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 is overwritten.


*1: for Hydraulic Brake Booster

*2: for Vacuum Brake Booster



PROCEDURE

1.RECONFIRM DTC

b.

Check if the same DTCs are output (See page Drivetrain>VF4BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTCs are output w/ Central Gateway ECU A
w/o Central Gateway ECU B
DTCs are not output C



A

B

C