Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the battery voltage.
11 to 14 V
OK
NG
(for 1GR-FE: See pagePower Source / Network>1GR-FE (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION)
(for 1KD-FTV: See pagePower Source / Network>1KD-FTV (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION)
(for 1GD-FTV: See page Power Source / Network>1GD-FTV (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION)
(for 5L-E: See pagePower Source / Network>5L-E (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION)
(for 2TR-FE: See page Power Source / Network>2TR-FE (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION)
Turn the ignition switch off.
Disconnect the G53 and G54 4 wheel drive control ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G53-21 (+B) - Body ground | Always | 11 to 14 V |
| G54-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
OK
NG
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G54-10 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
OK
NG