This DTC is output when communication is lost with the skid control ECU (master cylinder solenoid).
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| U0122 | 1.
Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) 2.
Communication is lost between skid control ECU and 4 wheel drive control ECU 3.
0.72 seconds or more when transfer is switching between high and low, when center differential is switching between free and lock, or when rear differential is switching between free and lock 4.
1 trip detection logic |
CAN communication system |
When the data in the skid control ECU (master cylinder solenoid) is being overwritten, the indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.
Clear all DTCs, since DTCs are stored after the data in the skid control ECU (master cylinder solenoid) is overwritten.
Clear the DTCs (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM (w/ Differential Lock)>DTC CHECK / CLEAR).
Check if the same DTCs are output (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM (w/ Differential Lock)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)