Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM (except 5L-E) › from 2017.08
RM27T0E _58 Vehicle Interior _053732 LIGHTING (INT) _0326432 LIGHTING SYSTEM(except 5L-E) U

LIGHTING (INT)  LIGHTING SYSTEM(except 5L-E)  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Main Body / Data List.


f.

Read the Data List according to the display on the GTS.

Main Body
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
ACC SW Ignition switch signal / OFF or ON OFF: Ignition switch off
ON: Ignition switch ACC
"ON" is also displayed for this item when the ignition switch is ON.
IG SW Ignition switch signal / OFF or ON OFF: Ignition switch off
ON: Ignition switch ON
"OFF" is also displayed for this item when the ignition switch is ACC.
Parking Brake SW Parking brake switch assembly signal / OFF or ON OFF: Parking brake switch off
ON: Parking brake switch on
-
FR Door Lock Pos Front door RH unlock detection switch signal / LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy Front door courtesy light switch assembly RH signal / OFF or ON OFF: Front door RH closed
ON: Front door RH open
-
FL Door Lock Pos Front door LH unlock detection switch signal / LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy Front door courtesy light switch assembly LH signal / OFF or ON OFF: Front door LH closed
ON: Front door LH open
-
RR Door Courtesy SW Rear door courtesy light switch assembly RH signal / OFF or ON OFF: Rear door RH closed
ON: Rear door RH open
for 5 Door
RR-Door Lock Pos SW Rear door RH unlock detection switch signal / OFF or ON OFF: Rear door RH locked
ON: Rear door RH unlocked
for 5 Door
RL Door Courtesy SW Rear door courtesy light switch assembly LH signal / OFF or ON OFF: Rear door LH closed
ON: Rear door LH open
for 5 Door
RL-Door Lock Pos SW Rear door LH unlock detection switch signal / OFF or ON OFF: Rear door LH locked
ON: Rear door LH unlocked
for 5 Door
Back Door Courtesy SW Back door courtesy light switch signal / OFF or ON OFF: Back door closed
ON: Back door open
-
Back Door Lock Pos SW Back door unlock detection switch LH signal / OFF or ON OFF: Back door locked
ON: Back door unlocked
-
Interior Lamp Brightness (Up) Room light switch assembly (Up switch) / OFF or ON OFF: Room light switch assembly (Up switch) off
ON: Room light switch assembly (Up switch) on
w/ Door Illumination Light
Interior Lamp Brightness (Down) Room light switch assembly (Down switch) / OFF or ON OFF: Room light switch assembly (Down switch) off
ON: Room light switch assembly (Down switch) on
w/ Door Illumination Light
Glass Hatch Courtesy Switch Glass hatch courtesy switch signal / OFF or ON OFF: Glass hatch closed
ON: Glass hatch open
w/ Glass Hatch Opener System



ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus:

i.

Body Electrical / Main Body / Active Test.


ii.

Body Electrical / Entry&Start / Active Test.


iii.

Body Electrical / Mirror L / Active Test.


iv.

Body Electrical / Mirror R / Active Test.



f.

Perform the Active Test according to the display on the GTS.

Main Body
Tester Display Measurement Item Normal Condition Diagnostic Note

*: w/o Entry and Start System

Illuminated Entry System Map light assembly, transponder key coil*, No. 1 room light assembly and No. 2 room light assembly OFF or ON Turn the map light assembly, No. 1 room light assembly and No. 2 room light assembly to the DOOR position.
Step Light Foot light assembly (side step light) OFF or ON w/ Side Step Light
Fr Foot Light No. 2 interior illumination light sub-assembly (footwell light) OFF or ON w/ Footwell Light
Relay for Interior Light Auto Cut Function DOME relay OFF or ON ON: DOME relay off (interior lights turn off)
OFF: DOME relay on (interior lights turn on)
Cent Consol Spot LGT Map light assembly (shift lever illumination light) OFF or ON w/ Shift Lever Illumination Light
Interior Illumination Light1 Front door illumination lights OFF or ON w/ Door Illumination Light
Interior Illumination Light2 Rear door illumination lights OFF or ON w/ Door Illumination Light

Entry&Start
Tester Display Measurement Item Control Range Diagnostic Note
Power/Engine SW Light Engine switch illumination OFF or ON -

Mirror L
Tester Display Test Part Control Range Diagnostic Note
Fr Foot Light Outer rear view mirror assembly LH (foot light LH) OFF or ON w/ Door Mirror Foot Light

Mirror R
Tester Display Test Part Control Range Diagnostic Note
Fr Foot Light Outer rear view mirror assembly RH (foot light RH) OFF or ON w/ Door Mirror Foot Light