INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
Perform this inspection with the customize parameters at the initial settings.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM (for 5L-E)>CUSTOMIZE PARAMETERS
Perform this inspection with the map light assembly, No. 1 room light assembly and No. 2 room light assembly are DOOR position.
| Control | Condition | Lights that Operate |
|---|---|---|
| Door Lock/Unlock-linked | With the ignition switch off and all of the doors closed and locked, unlock either front door using an unlock operation (key-linked or wireless) and check that the lights that operate turn on for 15 seconds and then turn off. | ·
Map light assembly ·
No. 1 room light assembly ·
No. 2 room light assembly |
| Door Open/Close-linked | With the ignition switch off and all of the doors closed, open either front door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds. | ·
Map light assembly ·
No. 1 room light assembly ·
No. 2 room light assembly |
| With the ignition switch ACC or ON, open either front door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off. | ·
Map light assembly ·
No. 1 room light assembly ·
No. 2 room light assembly |
|
| Ignition Switch-linked | Turn the ignition switch from ACC or ON to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map light assembly ·
No. 1 room light assembly ·
No. 2 room light assembly |
INSPECT BATTERY SAVING CONTROL OPERATION
The operations and conditions of this control are described below.
| Control | Condition | Lights that Operate |
|---|---|---|
| Basic operation | When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.
|
·
Map light assembly ·
No. 1 room light assembly ·
No. 2 room light assembly |
| Interior light auto cut operation | When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.
|
·
Map light assembly ·
No. 1 room light assembly ·
No. 2 room light assembly ·
Transponder key coil ·
Vanity light assembly |