Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › 2017.08–2018.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260460 NITROGEN OXIDES SENSOR A

1GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  REMOVAL  


PROCEDURE

Hide 89439K 1.REMOVE NO. 3 SENSOR BRACKET

A353017

a.

Remove the 2 bolts and No. 3 sensor bracket.


Hide 89463A 2.REMOVE NITROGEN OXIDES SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A406464

Remove the 2 bolts, detach the connector and 3 clamps, and then disconnect the harness and controller portion (No. 1 sensor bracket).


b.
A406465N01
0.615,1.25 0.771,1.25 0.771,1.25 1.083,0.948 true 0.281,1.167 0.615,1.354 0.333,0.188 10 true SST

Using SST, remove the nitrogen oxides sensor.

SST
09224-00012  


c.
A406466

Remove the 2 nuts, detach the 2 clamps, and then remove the No. 1 sensor bracket from the nitrogen oxides sensor.