Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › 2017.08–2018.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260460 NITROGEN OXIDES SENSOR A

1GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  INSTALLATION  


PROCEDURE

Hide 89463A 1.INSTALL NITROGEN OXIDES SENSOR

a.

Install the No. 1 sensor bracket with the 2 nuts to the nitrogen oxides sensor, and attach the 2 clamps.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.
A406467C01
1.5,0.583 1.813,0.865 1.813,0.865 1.969,0.865 true 0.406,0.458 0.646,0.635 0.24,0.177 10 true *a 2.031,0.771 2.385,0.969 0.354,0.198 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the nitrogen oxides sensor.

SST
09224-00012  

Torque:
Specified tightening torque : 55 N*m (561 kgf*cm, 41 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 49.2 N*m (502 kgf*cm, 36 ft.*lbf)




c.

Install the controller portion (No. 1 sensor bracket) with the 2 bolts, and then attach the connector and 3 clamps.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Complete the installation so that there is no tension or slack in the harness of the nitrogen oxides sensor, and there is no interference.



Hide 89439K 2.INSTALL NO. 3 SENSOR BRACKET

a.

Install the No. 3 sensor bracket with the 2 bolts.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)