Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH › from 2017.08
RM27T0E _59 Vehicle Exterior _053747 LIGHTING (EXT) _0326532 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84153 1.INSPECT AUTO HIGH BEAM SWITCH

a.

Inspect the auto high beam switch.

i.
E376394C01
1.083,1.813 1.302,1.26 true 1.896,1.813 2.115,1.26 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 0.979,1.854 1.292,2.052 0.313,0.198 10 false +B 1.844,1.854 2,2.052 0.156,0.198 10 false E
*a Component without harness connected
(Auto High Beam Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

If the result is not as specified, replace the auto high beam switch.

5(+B) - 2(E) Auto high beam switch off 10 kΩ or higher
Auto high beam switch on Below 1 Ω




b.

Inspect the Illumination.

i.
E376394C02
0.813,1.813 1.031,1.26 true 2.167,1.813 2.385,1.26 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 0.688,1.865 1.083,2.073 0.396,0.208 10 false ILL+ 2.052,1.854 2.469,2.083 0.417,0.229 10 false ILL-
*a Component without harness connected
(Auto High Beam Switch)


Apply battery voltage to the connector and check the illumination condition.

OK:
Battery Connection Specified Condition

If the result is not as specified, replace the auto high beam switch.

Positive (+) → 6(ILL+)
Negative (-) → 1(ILL-)
Illuminates