The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
The yaw rate and acceleration sensor has a built-in acceleration sensor and detects the vehicle condition.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1442 | An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. | Yaw rate and acceleration sensor (Airbag sensor assembly) |
| C1443 | An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more. | Yaw rate and acceleration sensor (Airbag sensor assembly) |
When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)