Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM › from 2017.08
RM27T0E _57 Power Source / Network _053729 NETWORKING _0261030 LIN COMMUNICATION SYSTEM J

NETWORKING  LIN COMMUNICATION SYSTEM  Rain Sensor LIN Communication Malfunction  


DESCRIPTION

When the auto wiper system is operated, the windshield wiper switch assembly uses LIN communication to communicate with the rain sensor. If the auto wiper system does not operate properly, a problem with the LIN communication between the windshield wiper switch assembly and rain sensor may be causing the malfunction.

WIRING DIAGRAM

C217430E16
5.146,0.458 5.552,0.625 0.406,0.167 10 false MPX 4.906,0.354 5.063,0.531 0.156,0.177 10 false 1 1.479,0.448 1.979,0.615 0.5,0.167 10 false MPX1 2.052,0.333 2.333,0.531 0.281,0.198 10 false 14 0.938,0.969 1.427,1.135 0.49,0.167 10 false G210 0.927,1.156 3.396,1.385 2.469,0.229 10 false Windshield Wiper Relay Assembly 5.104,0.969 5.396,1.135 0.292,0.167 10 false W6 5.104,1.146 5.958,1.344 0.854,0.198 10 false Rain Sensor

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY - RAIN SENSOR)
a.

Disconnect the G210 windshield wiper switch assembly connector.


b.

Disconnect the W6 rain sensor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G210-14 (MPX1) - W6-1 (MPX) Always Below 1 Ω
G210-14 (MPX1) or W6-1 (MPX) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR