Use the following procedure to troubleshoot the heated windshield defroster system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the windshield deicer system is functioning normally.
Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD DEICER SYSTEM>OPERATION CHECK
| Result | Proceed to |
|---|---|
| Windshield deicer system is functioning normally | A |
| Windshield deicer system is not functioning normally | B |
A
B
Using the GTS, check for CAN communication system DTCs.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
A
B
Refer to the Problem Symptoms Table.
Click hereVehicle Exterior>WINDOW / GLASS>HEATED WINDSHIELD DEFROSTER SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test
Click hereVehicle Exterior>WINDOW / GLASS>HEATED WINDSHIELD DEFROSTER SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click hereVehicle Exterior>WINDOW / GLASS>HEATED WINDSHIELD DEFROSTER SYSTEM>TERMINALS OF ECU
Operation Check
Click hereVehicle Exterior>WINDOW / GLASS>HEATED WINDSHIELD DEFROSTER SYSTEM>OPERATION CHECK
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT