Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › from 2017.08
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261257 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Headlight Signal Circuit  


DESCRIPTION

The headlight cleaner control relay detects the low beam headlights status.

WIRING DIAGRAM

B488723E01
4.458,2.708 4.781,2.885 0.323,0.177 10 false A38 4.448,2.865 6.427,3.125 1.979,0.26 10 false Headlight Cleaner Control Relay 4.802,0.958 4.958,1.156 0.156,0.198 10 false 1 5.031,1.083 5.469,1.281 0.438,0.198 10 false HDLO 0.094,1.073 2.052,1.469 1.958,0.396 10 false from Main Body ECU (Multiplex Network Body ECU) 3.719,1.677 4.031,1.875 0.313,0.198 10 false *2 2.927,0.927 3.24,1.125 0.313,0.198 10 false *1 0.458,2.219 2.083,2.667 1.625,0.448 10 false from No. 1 Headlight ECU Sub-assembly RH 0.135,3.417 1.635,3.646 1.5,0.229 10 false *2: for LED Headlight 0.146,3.104 1.719,3.292 1.573,0.188 10 false *1: for Halogen Headlight

CAUTION / NOTICE / HINT

NOTICE:

First check that the low beam headlights operate normally.


PROCEDURE

1.CHECK HEADLIGHT CLEANER CONTROL RELAY (HDLO VOLTAGE)
a.
B488724E01
1.51,0.26 1.917,0.49 0.406,0.229 0.781,1.5 0.979,1.5 0.979,1.5 1.438,1.104 true 0.125,0.063 0.438,0.26 0.313,0.198 10 false *a 1.573,0.281 1.896,0.5 0.323,0.219 10 false A38 0.344,1.417 0.771,1.625 0.427,0.208 10 false HDLO

Disconnect the headlight cleaner control relay connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A38-1 (HDLO) - Body ground Headlight dimmer switch in head 11 to 14 V
A38-1 (HDLO) - Body ground Headlight dimmer switch not in head Below 1 V


Text in Illustration
*a Front view of wire harness connector
(to Headlight Cleaner Control Relay)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR