Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261086 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1690  Side Airbag Sensor RH  B1695  Side Airbag Sensor LH  


DESCRIPTION

The side airbag sensor LH or RH consists of the safing sensor, diagnostic circuit, lateral deceleration sensor, etc.

If the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.

DTC B1690 or B1695 is stored when a malfunction is detected in the side airbag sensor LH or RH circuit.

DTC Code DTC Detection Condition Trouble Area
B1690 Either condition is met:
·

A side airbag sensor RH malfunction.

·

A center airbag sensor malfunction.


·

Side airbag sensor assembly RH

·

Center airbag sensor


B1695 Either condition is met:
·

A side airbag sensor LH malfunction.

·

A center airbag sensor malfunction.


·

Side airbag sensor assembly LH

·

Center airbag sensor



WIRING DIAGRAM

C171802E09
0.091,0.02 1.164,0.280 1.073,0.260 12 for RH Side: 5.696,2.749 6.171,2.889 0.475,0.140 10 BCR- 5.696,1.418 6.171,1.558 0.475,0.140 10 BCR+ 5.433,2.655 5.609,2.830 0.175,0.175 10 1 5.433,1.304 5.609,1.479 0.175,0.175 10 2 1.147,2.749 1.622,2.889 0.475,0.140 10 BCR- 1.147,1.418 1.622,1.558 0.475,0.140 10 BCR+ 3.461,2.757 3.763,2.896 0.302,0.140 10 JQ1 3.48,1.412 3.763,1.551 0.282,0.140 10 JQ1 1.681,2.655 1.856,2.830 0.175,0.175 10 2 1.681,1.304 1.842,1.479 0.161,0.175 10 1 3.547,2.563 3.722,2.739 0.175,0.175 10 2 3.547,1.213 3.673,1.388 0.126,0.175 10 1 5.308,3.836 5.634,4.000 0.325,0.164 10 J8 5.308,4.015 7.119,4.198 1.810,0.183 10 Side Airbag Sensor RH 0.463,3.836 0.719,4.000 0.256,0.164 10 Q4 0.463,4.015 2.393,4.198 1.929,0.183 10 Rear Airbag Sensor RH

C171802E10
0.091,0.02 1.164,0.280 1.073,0.260 12 for LH Side: 5.696,2.749 6.171,2.889 0.475,0.140 10 BCL- 5.696,1.418 6.171,1.558 0.475,0.140 10 BCL+ 5.433,2.655 5.609,2.830 0.175,0.175 10 1 5.433,1.304 5.609,1.479 0.175,0.175 10 2 1.147,2.749 1.622,2.889 0.475,0.140 10 BCL- 1.147,1.418 1.622,1.558 0.475,0.140 10 BCL+ 3.458,2.757 3.763,2.896 0.304,0.140 10 KR1 3.458,1.422 3.763,1.562 0.304,0.140 10 KR1 1.681,2.655 1.856,2.830 0.175,0.175 10 2 1.681,1.304 1.842,1.479 0.161,0.175 10 1 3.547,2.563 3.722,2.739 0.175,0.175 10 1 3.547,1.213 3.673,1.388 0.126,0.175 10 2 5.308,3.836 5.634,4.000 0.325,0.164 10 K8 5.308,4.015 7.098,4.187 1.789,0.172 10 Side Airbag Sensor LH 0.463,3.836 0.719,4.000 0.256,0.164 10 R4 0.463,4.015 2.393,4.198 1.929,0.183 10 Rear Airbag Sensor LH

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

·

After replacing the center airbag sensor, refer to initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.CHECK FOR DTC
a.

Turn the ignition switch to ON.



c.

Turn the ignition switch off.


d.

Turn the ignition switch to ON, and wait for at least 60 seconds.


e.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1690 and B1695 are not output A
DTC B1695 is output B
DTC B1690 is output C



C

2.CHECK SIDE AIRBAG SENSOR RH

A

B

3.CHECK SIDE AIRBAG SENSOR LH
2.CHECK SIDE AIRBAG SENSOR RH
a.
C171828E15
0.469,1.49 0.635,1.649 0.165,0.158 10 *1 2.141,1.49 2.304,1.656 0.163,0.165 10 *2

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Interchange the side airbag sensor RH with LH and connect the connectors to them.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.



g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1690 and B1695 are not output A
DTC B1695 is output B
DTC B1690 is output C

HINT:

Codes other than DTC B1690 and B1695 may be output at this time, but they are not related to this check.


Text in Illustration
*1 Side Airbag Sensor LH
*2 Rear Airbag Sensor RH


j.

Turn the ignition switch off.


k.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


l.

Return the side airbag sensor RH and LH to their original positions and connect the connectors to them.



C

A

B

3.CHECK SIDE AIRBAG SENSOR LH
a.
C171828E15
0.469,1.49 0.635,1.649 0.165,0.158 10 *1 2.141,1.49 2.304,1.656 0.163,0.165 10 *2

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Interchange the side airbag sensor RH with LH and connect the connectors to them.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.



g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1690 and B1695 are not output A
DTC B1690 is output B
DTC B1695 is output C

HINT:

Codes other than DTC B1690 and B1695 may be output at this time, but they are not related to this check.


Text in Illustration
*1 Side Airbag Sensor RH
*2 Rear Airbag Sensor LH


j.

Turn the ignition switch off.


k.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


l.

Return the side airbag sensor RH and LH to their original positions and connect the connectors to them.



C

A

B