Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053736 PRE-CRASH SAFETY _0261101 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  UTILITY  


NOTICE:
·

When replacing a millimeter wave radar sensor assembly, replace it with a new one. When the millimeter wave radar sensor assembly is replaced with a new one, it stores the country specification information received from the driving support ECU assembly.

If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.

·

If the millimeter wave radar sensor assembly has been replaced, be sure to perform Front Beam Axis Adjustment. If not performed, DTC C1A14 will be stored when the system is turned on.



Control Mode


HINT:
·

This mode is used to check the operation of the pre-crash safety system when reproducing situations when the pre-crash safety system operated unnecessarily.

·

Operating the pre-crash brake assist control or pre-crash braking control when reproducing problem symptoms may lead to a dangerous situation. To avoid this, do not attempt to operate the pre-crash braking control, only operate the pre-crash warning control (buzzer and warning message) when reproducing the problem symptoms.

PCS Control Operated Buzzer Sound
Pre-crash warning control Intermittent (Long)
Pre-crash brake assist control Intermittent (Short)
Pre-crash braking control Continuous



a.

Connect the GTS to the DLC3.


b.

Enter the following menus: Body Electrical / Pre-Crash 2 / Utility / Control Mode.


c.

Perform Control Mode according to the display on the GTS.



Front Beam Axis Adjustment


HINT:

Front Beam Axis Adjustment of the millimeter wave radar sensor assembly is performed using the GTS.


a.

Perform Front Beam Axis Adjustment according to the display on the GTS.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT



Front Beam Axis Misalignment Reading


HINT:

The amount of misalignment of the millimeter wave radar sensor assembly can be checked using the GTS.


a.

Perform Front Beam Axis Misalignment Reading according to the display on the GTS.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT



Front Beam Axis Offset Reading


HINT:

The offset of the millimeter wave radar sensor assembly can be checked using the GTS.


a.

Perform Front Beam Axis Offset Reading according to the display on the GTS.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT



History Clear


HINT:

If the status of any history data is "ON", clear the history data.


a.

Connect the GTS to the DLC3.


b.

Enter the following menus: Body Electrical / Pre-Crash 2 / Utility / History Clear.


c.

Perform History Clear according to the display on the GTS.