Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053736 PRE-CRASH SAFETY _0261101 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  U0100  Lost Communication With ECM/PCM "A"  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect objects in front of the vehicle. Based on signals from the millimeter wave radar sensor assembly, the driving support ECU assembly sends pre-crash safety system control operation signals. These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-crash safety system control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication With ECM/PCM "A" When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and the driving support ECU assembly is detected for approximately 5 seconds.
·

CAN communication system

·

ECM

·

Driving support ECU assembly

·

Harness or connector


U0125 Lost Communication with Yaw Rate Sensor Module When the ignition switch is ON, a communication error between the yaw rate sensor (airbag sensor assembly) and the driving support ECU is detected for approximately 1 second.
·

CAN communication system

·

Yaw rate sensor (airbag sensor assembly)

·

Driving support ECU assembly

·

Harness or connector


U0126 Lost Communication with Steering Angle Sensor Module When the ignition switch is ON, a communication error between the steering sensor and the driving support ECU assembly is detected for approximately 4 seconds.
·

CAN communication system

·

Steering sensor

·

Driving support ECU assembly

·

Harness or connector


U0129 Lost Communication with Brake System Control Module
·

for 2TR-FE:

When the ignition switch is ON, a communication error between the skid control ECU (brake actuator assembly) and the driving support ECU assembly is detected for approximately 3 seconds.

·

except 2TR-FE:

When the ignition switch is ON, a communication error between the skid control ECU (master cylinder solenoid) and the driving support ECU assembly is detected for approximately 3 seconds.


·

CAN communication system

·

Skid control ECU assembly (brake actuator assembly) (for 2TR-FE)

·

Skid control ECU assembly (master cylinder solenoid) (except 2TR-FE)

·

Driving support ECU assembly

·

Harness or connector



PROCEDURE

1.CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.




Result:
Result Proceed to
DTC U0100, U0125, U0126 and U0129 are not output A
DTC U0100, U0125, U0126 or U0129 is output B



A

B