Use these procedures to troubleshoot the glass hatch opener system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the CAN communication system is functioning normally
w/ Central Gateway ECU:
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>PRECAUTION
w/o Central Gateway ECU:
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>PRECAUTION
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs are output (w/ Central Gateway ECU) | B |
| DTCs are output (w/o Central Gateway ECU) | C |
A
B
C
Refer to the Problem Symptoms Table.
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in problem symptoms table |
| Fault is listed in problem symptoms table |
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Operation Check
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>OPERATION CHECK
Terminals of ECU
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>TERMINALS OF ECU
Data List / Active Test
Click hereVehicle Exterior>WINDOW / GLASS>GLASS HATCH OPENER SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT