Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › UREA INJECTOR › from 2017.08
RM27T0E _51 Engine / Hybrid System _053675 1GD-FTV EMISSION CONTROL _0260629 UREA INJECTOR A

1GD-FTV EMISSION CONTROL  UREA INJECTOR  REMOVAL  


PROCEDURE

Hide 77840 1.DISCONNECT UREA TUBE WITH HEATER ASSEMBLY

NOTICE:

Check for dirt or mud on the urea injector set and around the urea tube with heater connector before disconnection. Clean if necessary.


a.

Disconnect the urea tube with heater assembly from the urea injector set.

i.
A409323C01
2.458,0.583 2.844,0.302 2.844,0.302 3.073,0.302 true 3.104,0.208 3.365,0.406 0.26,0.198 10 true *a
*a Retainer
V100135

Pull
V100136

Pull Out


Detach the claw of the retainer of the urea tube with heater connector, pull up the retainer and disconnect the urea tube with heater connector from the urea injector set.

NOTICE:
·

If there is any solidified urea solution (white solids) on the connection area, clean the solids off with a damp cloth, etc., before disconnecting the connector.

·

Be sure to disconnect the urea tube with heater connector by hand.

·

Check for foreign matter in the urea injector set and around the urea tube with heater connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the urea injector set and urea tube with heater connector.

·

Put the urea injector set and urea tube with heater connector ends in plastic bags to prevent damage and foreign matter contamination.





Hide 23203 2.REMOVE UREA INJECTOR SET

a.
A352187

Disconnect the connector from the urea injector set.


b.
A352188

Remove the 2 nuts and urea injector set and gasket from the front exhaust pipe assembly.