84250A
1.INSPECT STEERING PAD SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| *1 | with ACC switch | *2 | with LDA switch |
| *3 | with Voice switch | *4 | w/ Hook Switch |
| *5 | with VGRS | - | - |
| *a | Seek+ Switch | *b | Seek- Switch |
| *c | Volume+ Switch | *d | Volume- Switch |
| *e | MODE Switch | *f | Voice Switch |
| *g | Off Hook Switch | *h | On Hook Switch |
| *i | LEFT | *j | RIGHT |
| *k | UP | *l | DOWN |
| *m | ENTER | *n | BACK |
| *o | TOP | *p | ACC |
| *q | LDA | - | - |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 11 (AU1) - 8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Seek+ switch pushed | Below 2.5 Ω | |
| Seek- switch pushed | 313 to 345 Ω | |
| Volume+ switch pushed | 950 to 1050 Ω | |
| Volume- switch pushed | 2955 to 3265 Ω | |
| 10 (AU2) - 8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Mode switch pushed | Below 2.5 Ω | |
| Voice switch pushed | 2955 to 3265 Ω | |
| On Hook switch pushed | 313 to 345 Ω | |
| Off Hook switch pushed | 950 to 1050 Ω | |
| 2 (+DP) - 8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Left switch pushed | Below 2.5 Ω | |
| Right switch pushed | 2955 to 3265 Ω | |
| Up switch pushed | 313 to 345 Ω | |
| Down switch pushed | 950 to 1050 Ω | |
| 4 (DIST) - 7 (ECC) | No switch is pushed | 1MΩ or higher |
| ACC switch pushed | Below 2.5 Ω | |
| LDA switch pushed | 228 to 252 Ω | |
| HO - 1 (HO) | Always | Below 2.5 Ω |
| VGRS - 9 (GND1) | Always | Below 2.5 Ω |
If the result is not as specified, replace the steering switch.
Connect the battery positive (+) lead to terminal 5 (IL+2) and the negative (-) lead to terminal 8 (EAU) of the steering pad switch connector.
Check that the switch illumination comes on.
Steering pad switch illumination comes on.
If the result is not as specified, replace the steering pad switch.
84247A
2.INSPECT STEERING PAD SWITCH LH
Measure the resistance according to the value(s) in the table below.
| *1 | with Hook Switch | *2 | with VGRS |
| *a | Seek+ Switch | *b | Seek- Switch |
| *c | Volume+ Switch | *d | Volume- Switch |
| *e | MODE Switch | *f | Off Hook Switch |
| *g | On Hook Switch | - | - |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 11 (AU1) - 8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Seek+ switch pushed | Below 2.5 Ω | |
| Seek- switch pushed | 313 to 345 Ω | |
| Volume+ switch pushed | 950 to 1050 Ω | |
| Volume- switch pushed | 2955 to 3265 Ω | |
| 10 (AU2) - 8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Mode switch pushed | Below 2.5 Ω | |
| On Hook switch pushed | 313 to 345 Ω | |
| Off Hook switch pushed | 950 to 1050 Ω | |
| HO - 1 (HO) | Always | Below 2.5 Ω |
| VGRS - 9 (GND1) | Always | Below 2.5 Ω |
If the result is not as specified, replace the steering pad switch.
Connect the battery positive (+) lead to terminal 5 (IL+2) and the negative (-) lead to terminal 8 (EAU) of the steering pad switch assembly connector.
Check that the switch illumination comes on.
Steering pad switch illumination comes on.
If the result is not as specified, replace the steering pad switch.