Home › Steering › STEERING COLUMN › TILT AND TELESCOPIC MANUAL SWITCH › 2017.08–2020.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260961 TILT AND TELESCOPIC MANUAL SWITCH A

STEERING COLUMN  TILT AND TELESCOPIC MANUAL SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.

Disable the auto tilt away function by changing the customize parameter (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).

NOTICE:

Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.


HINT:

Performing the above operation causes the auto tilt away function to be disabled when the engine switch is turned off.



b.

Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.


c.

Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).




Hide 45287 3.REMOVE STEERING COLUMN LOWER COVER

a.
C384117

Remove the 3 screws.


b.

Detach the 2 claws and remove the steering column lower cover.

NOTICE:

Do not damage the tilt and telescopic switch.



Hide 89235A 4.REMOVE TILT AND TELESCOPIC SWITCH

a.
C215874

Disconnect the connector.


b.

Detach the claw and pull out the tilt and telescopic switch.

NOTICE:

Pushing on the claw too hard will break the claw.