This circuit provides power to the radio and display receiver assembly.
Inspect the fuse for circuits related to this system before performing the following procedure.
Disconnect the radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H49-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H49-4 (+B1) - Body ground | Always | 11 to 14 V |
| H49-3 (ACC1) - Body ground | Ignition switch ACC | 11 to 14 V |
| H51-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
OK
NG