DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body or Master Switch / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ACC SW | Ignition switch / ON or OFF | ON: ignition switch ACC or ON
OFF: ignition switch off |
"ON" is also displayed for this item when the ignition switch is ON. |
| IG SW | Ignition switch / ON or OFF | ON: ignition switch ON
OFF: ignition switch off or ACC |
"OFF" is also displayed for this item when the ignition switch is ACC. |
| RR Door Courtesy SW* | Rear door courtesy light switch RH signal / ON or OFF | ON: Rear door RH open
OFF: Rear door RH closed |
- |
| RL Door Courtesy SW* | Rear door courtesy light switch LH signal / ON or OFF | ON: Rear door LH open
OFF: Rear door LH closed |
- |
| Back Door Courtesy SW | Back door courtesy switch signal / ON or OFF | ON: Back door open
OFF: Back door closed |
- |
| Back Door Lock Pos SW | Back door lock position switch signal / ON or OFF | ON: Back door unlocked
OFF: Back door locked |
- |
| Door Key SW-Lock | Driver side door key-linked switch lock signal / ON or OFF | ON: Driver side door key cylinder turned to lock position
OFF: Driver side door key cylinder not turned to lock position |
- |
| D Door Key SW-UL | Driver side door key-linked switch unlock signal / ON or OFF | ON: Driver side door key cylinder turned to unlock position
OFF: Driver side door key cylinder not turned to unlock position |
- |
| FR Door Lock Pos | Front door lock position switch RH signal / LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FR Door Courtesy SW | Front door courtesy light switch RH signal / ON or OFF | ON: Front door RH closed
OFF: Front door RH open |
- |
| FL Door Lock Pos | Front door lock position switch LH signal / LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| FL Door Courtesy SW | Front door courtesy light switch LH signal / ON or OFF | ON: Front door LH closed
OFF: Front door LH open |
- |
| RR-Door Lock Pos SW* | Rear door lock position switch RH signal / ON or OFF | ON: Rear door RH unlocked
OFF: Rear door RH locked |
- |
| RL-Door Lock Pos SW* | Rear door lock position switch LH signal / ON or OFF | ON: Rear door LH unlocked
OFF: Rear door LH locked |
- |
| The Number of DTC | Number of trouble codes / Min.: 0, Max.: 255 | Number of DTCs stored | - |
*: for 5 Door
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Door Lock Switch Status | Driver side door control switch lock signal / ON or OFF | ON: Lock side of driver side door control switch pushed
OFF: Lock side of driver side door control switch not pushed |
- |
| Door Unlock Switch Status | Driver side door control switch unlock signal / ON or OFF | ON: Unlock side of driver side door control switch pushed
OFF: Unlock side of driver side door control switch not pushed |
- |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Door Lock | Operate door lock motor | Unlock/Lock/OFF | - |
| D-Door Unlock | Operate driver side door lock motor | ON/OFF | - |
| Shock Detection Unlock* | Operate door lock motor | UNLOCK/LOCK | - |
*: w/ Door Control Battery