Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
84010A
3.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
86140A
4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
Remove the 4 bolts.
Pull the radio and display receiver assembly to detach the 7 clips, 2 guides on the backside of the radio and display receiver assembly.
Disconnect each connector and remove the radio and display receiver assembly.
86841
5.REMOVE NAVIGATION ECU (w/ Navigation System)
86211J
6.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 1 radio receiver bracket.
86212C
7.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 2 radio receiver bracket.
55670A
8.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY