| DTC Code | DTC Detection Conditions | Trouble Area |
|---|---|---|
| U0073 | One of the following conditions is met:
·
When the IG1 terminal voltage is between 10 and 17.4 V, after the output of data from the skid control ECU is completed, the sending operation continues for 5 seconds or more. ·
The condition that bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession (Sent signals cannot be received). ·
When the IG1 terminal voltage is between 10 and 17.4 V, a delay in receiving data from the yaw rate and acceleration sensor (airbag sensor assembly) and steering sensor continues for 1 second or more. ·
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that a delay in receiving data from the yaw rate and acceleration sensor (airbag sensor assembly) and steering sensor occurs more than once within 5 seconds. |
CAN communication system |
| U0100 | Either condition is met:
·
When the IG1 terminal voltage is between 10 and 17.4 V and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to the ECM for 2 seconds or more. ·
When the IG1 terminal voltage is between 10 and 17.4 V and the vehicle speed is 15 km/h (9 mph) or more, data cannot be received from the ECM for 2 seconds or more. |
CAN communication system |
| U0114 | The CAN signal from the 4 wheel drive control ECU is lost or malfunctioning for 1.2 seconds. | CAN communication system |
| U0123 | Either condition is met:
·
When the IG1 terminal voltage is between 10 and 17.4 V, data from the yaw rate sensor cannot be received for 1 second or more. ·
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that data from the yaw rate sensor cannot be received occurs once or more within 5 seconds. |
CAN communication system |
| U0124 | Either condition is met:
·
When the IG1 terminal voltage is between 10 and 17.4 V, data from the acceleration sensor cannot be received for 1 second or more. ·
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that data from the acceleration sensor cannot be received occurs once or more within 5 seconds. |
CAN communication system |
| U0126 | One of the following conditions is met:
·
When the IG1 terminal voltage is between 10 and 17.4 V, data from the steering sensor cannot be received for 1 second or more ·
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. ·
The condition that data from the steering sensor cannot be received occurs once or more within 5 seconds. |
CAN communication system |
Check if the same DTC(s) is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (w/ Central Gateway ECU) | B |
| DTC is output (w/o Central Gateway ECU) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C